NICE 2 1/2 Lb Cross Peen Hammer... Here is a great all around forging hammer for general use.. This hammer is in excellent condition and work ready.. the hammer's face is flat and smooth without chips

 

This is a 14 In. Bell System-B Ratcheting Bit Brace This bit brace is in very good condition. It is 14 inches long with a 10 inch sweep. Has minor scratches from normal use. Has no rust or pitting. Al

 

Estate purchased. It is 6 1/2" tall. Please see the pictures for your evaluation of this item. This is a neat looking tool. If you would like further pictures or have questions please ask. Check my ot

 

To heavy duty soldering irons. One is made by Lenks, the other has no name.but both of them works.

 

THIS EARLY WINCHESTER FLASHLIGHT IS IN REAL NICE CONDITION FOR IT'S AGE, BOTH ENDS OPEN AND CLOSE NICELY AND THE SWITCH WORKS. THE BOTTOM IS MARKED 'WINCHESTER FLASHLIGHT' OVER A LARGE LETTER W. PAYPA

 

snap on 1/2" drive locking flex head ratchet new slx80a

 

In this auction you are bidding on : .....VINTAGE SNAP ON TOOLS HEX RETHREADER DIE SET.... Made by SNAP ON TOOLS, USA. Snap On Tool Number TRC-7A. Comes with 7 different Dies. 5/8-NC, 9/16-NC, 1/2-NC,

 

THIS AUCTION IS FOR A STANLEY #60 1/2 BLOCK PLANE FROM THE 1950 S.IT IS IN EXCELLENT CONDITION. ALL PARTS ARE ORIGIONAL TO THIS PLANE, IT SHOWS LOW USE. SHIPPING - $6.00 TO THE LOWER 48 UNITED STATES.

 

SNAP ON-S 9716-12PT BOX END SHOCK ABSORBER WRENCH 1/2 Condition: In good condition! They have minor wear from previous use. Let me know if you have any questions. _gsrx_vers_486 (GS 6.5.1 (486))

 

Time to clean out some of my Delta Milwaukee-Rockwell-Homecraft USED Parts and Goodies I have had around for years. More To Come.....Keep watching for Delta woodworking and Machinery Parts over the Ne