A Large, Old BROAD AXE HEAD. It is 8 ¾” wide x 11” across Blade edge. There is a “flaw” on one side at edge of the Eye (See Pic), otherwise in good condition. Rust/Pitting ~ Normal ageing. Bu

 

VINTAGE SNAP-ON XDH 3032 & XDH 2830 12 POINT BOX WRENCHES IN NICE USED CONDITION WATCH MY OTHER LISTINGS FOR MORE VINTAGE SNAP-ON TOOLS FROM A LARGE COLLECTION I JUST PURCHASED AND SAVE ON SHIPPIN

 

A very nice Cast Iron Block Plane with the original cutting iron and wood wedge. The Plane is 5-1/2 inches long X 2-1/4 inch wide X 1-1/2 inches high. The body of the plane has no rust and the japanni

 

Here's a nice little Norlund mini hatchet. The head measures 5 1/8" with the cutting edge 3 1/8". The handle is nice and tight and the head has no mushrooming, has never used as a hammer. Ready for ca

 

One dozen vintage flat and skeleton keys. Some may be dirty.

 

FOR WATER PUMP NUTS ONLY IN RAISED LETTERS.UNUSUAL SHAPE.ABOUT 13" LONG.WOULD HOLD A 3" NUT.HEAVY DUTY.NO RUST.GOOD CONDITION.I WAS TOLD TODAY THIS IS A CATERPILLAR HEAVY EQUIPMENT WRENCH.

 

W C KELLY PERFECT DOUBLE BIT AXE HEAD, CHARLESTON W. VA. USA, TRUE TEMPER 4-2(WEIGHS 4LBS 4OUNCES) . ALL OF THIS INFO IS ON THE AXE HEAD AND ALL READABLE, IT DOES HAVE SOME PITTING , RUST , DINGS ETC.

 

5 Stanely chisels (1/4", 1/2", 3/4", 1", 1 1/2"). Nice clean set of chisels. Backs have been flattened and have a mirror finish. Freshly sharpened (25 degree primary, 2 degree micro bevel). Razor shar

 

RIMCO ROBERT IVENS MACHINERY COMPANY 613 W. Bruce St.Milwaukee WI 53204414-272-6686 Welcome to Robert Ivens Machinery Company Our Mission: Productive and Satisfied Customers Up for AUCTION: RIDGID NO.

 

PLEASE SETTLE ALL INQUIRIES & QUESTIONS BEFORE YOU BID! CAREFULLY EXAMINE LISTING PHOTOSand ALWAYS READ THE COMPLETE DESCRIPTION and YOUR AGREED TO TERMS BELOW: This offering found in the pantry u