Vintage 1878 to 1888 DISSTON D-8 CROSSCUT HANDSAW 8ppi. Saw blade is straight, no rust or deep pits, etch is faint but there. No broken or missing teeth. Except for the top horn missing, the handle is

 

Sherman & Reilly Inc aluminum pulley. Measuring approximately 12" long total  length pulley itself is 7" diameter. Feel free to ask any questions my photos are my best description.

 

Your browser does not support JavaScript. To view this page, enable JavaScript if it is disabled or upgrade your browser. Click Here. Double your traffic. Get Vendio Gallery - Now FREE! Patented Ca. 1

 

YOU ARE BIDDING ON A VINTAGE AND ORIGINAL KEEN KUTTER HATCHET THAT IS IN VERY GOOD TO TERRIFIC CONDITION SHOWING THE NORMAL WEAR FROM USE(SEE PICTURE). IT HAS THE "KEEN KUTTER" TOOLS LOGO ON THE HATCH

 

Atlas Copco, Jiffy, Dotco and assorted Aricraft tools. Including Bushings and step up reamers. Make me an offer. Everything from 500 Rpm 1/2 inch Drill to 3300 Palm motors. Also including angle motors

 

Here we have a huge old leg vice. I don't see any cracks, breaks, or welds. The jaws measure 6 inches wide. See pictures for condition. What you see is what you get. Selling as is. Please ask question

 

Here we have a STANLEY No. 110 Block Plane in very nice condition.I would say it is new but I found a few small wood shavings on the plane so I beleive it was tested and been used once or twice. Had s

 

(2) NEW Lufkin "Red End" Flat Read Wood Folding Engineer's Rule The white one is 8' the yellow one it 6' Posted with eBay Mobile

 

Here's a rather rare pair of Hunter 10M-8 "Magic Tip" screw-holding screw drivers. These were patented in 1943 by J. Hagness. These work very nicely as they should.. Just as if they were new. These ar

 

3/8 dr. Champion Plug master flex ratchet excellent mechanical condition!!!