This is an old Microflame gas welding torch kit that is complete in the original box and more than likely never been used. It uses compressed butane. The package is a little beat up from being moved a

 

STANLEY 9 3/4" cost airon plane , marked STALEY H1204(12-204) made in USA, insade marked C557 MP, look at the picture

 

Here's a rather rare pair of Hunter 10M-8 "Magic Tip" screw-holding screw drivers. These were patented in 1943 by J. Hagness. These work very nicely as they should.. Just as if they were new. These ar

 

I am original owner, and purchased these in the early 1980s. The following items are included: Socket Size Part No. 3/4 32-1224 11/16 32-1222 5/8 32-1220 9/16 32-1218 1/2 32-1216 7/16 32-1214

 

A great collectable MASSEY FERGUSON EN18 Tractor spanner with the usual markings as shown in pics. In good used condition.

 

Antique RadiopticanH.C. White Co North Bennington VT USAPatents pending Unit is 11.5" wide x 9" deep x 9" tallIncludes slide off back door, two internal reflectors, lens. Missing one chimney. I chicke

 

Up for bids is a Stanley #199 knife with Shell emblem on it.In good working condition. Thanks for looking.

 

This listing is for a set of Craftsman metric box end wrenches. The wrenches are in good used condition. The wrenches are in sizes 6-8 mm, 7-9 mm, 10-11 mm, 12-14 mm, 13-15 mm and 17-19 mm. The wrench

 

· Good Working Condition · Patent Date: 8-22-15 · Still Retains Most of the Original Japan Finish

 

You are bidding on an old antique woodworking tool. This vintage saw is made by Henry Disston and Sons. The makers mark is barely legible, in the right light at the right angle, you can make out what