This is a vintage #4 planer. I'm not sure on the maker. Pleas see picture for condition 

 

VintageStamped:TESTEDToo Many ScratchesCan't Read The Makers MarkRock HammerWeighs About:1 lb 10 ozMeasures About:14 & 7/8" Long6" WideI Am Not A Hammer ExpertCheck Pictures& Judge For Yoursel

 

Sears Craftsman Combination Wrench Set. 11 wrenches size 7/8" thru 5/16" by 1/16 ths with the 11/32" wrench added to the set. Notes: The 13/16" wrench is a Craftsman "BF" series replacement wrench and

 

I HAVE UP FOR AUCTION AND YOUR CONSIDERATION A VERY OLD LEVEL. "STANLEY PAT. JUNE 23, 98" ACROSS THE SMALL LEVEL. THIS METAL LEVEL MEASURES 3 1/8" LONG X 5/8" WIDE. CONDITION: VERY GOOD..LEVEL WORKS G

 

Antique FORDSON 10" no.80 adjustable wrench.Side one is marked: FORDSON, THE KEYSTONE MFG. CO..Side two is marked: BUFFALO, NY., U.S.A.,10 INCH, NO.80.It measures approx. 10" long and it has a slight

 

This is a vintage Lakeside double bit axe in good sound condition. It is 10 7/8" end to end and 4 3/8" at bits. The axe weighs 3 lbs 9 ozs and is free of wood, the axe handle side of the eye is in gre

 

Millers Falls No. 5 manual drill, some rust, some original paint. From the Millers Falls Tool Co. Greenfield Mass. Not locked up, no excessive play, chuck works fine about 13" overall length. Paypal o

 

Up for auction is a Vintage G. I. Mix & Co No.1 EX Wood Chisel 3/4" Wide with No Handle. It is 8 1/2" long and has some wear and some staining and light rust but is in good used condition. There i

 

This is a lot with of five hollow barrel keys. They are approximately 1 3/4 inches long with a top diameter of approximately 5/8 inch. Thanks for looking!

 

General Hardwear Mfg. Co. N.Y. Multi gauge. No. 16, 1937. Rule, protractor, square, centre finder, circle divider, drill point gauge etc.