On Offer; A nice vintage 1 1/2" Wood Chisel made in China. The Chisel is 10" long overall with a 5 3/4" blade. The blade is marked with a diamond or jewel logo and Made in China on the bottom and 1 1/

 

This is a vintage Collins Hudson Bay axe that could almost be labeled new old stock it is so clean. The photos should show the beautiful head, clear, deep stamp, and vintage slim handle. To get one an

 

A beautiful Stanley/Bailey 5 1/2 corrugated plane, with finish baked on. The base is rust and pit free. There are three patent dates behind the frog, the last being APR/19/10. The bottom shows a sligh

 

There is a Barron multi purpose wood planer, three small hammers, a 1-32 KK punch, a Stanley Yankee #4595 screwdriver, a cast iron level, no maker's mark, a 6 inch sliding T bevel, two sandcasting too

 

The f70n ratchet is stamped G government. Speed driver F-4-A 1939 date code, F-5 breaker bar stamped 1941, F-10 breaker bar undated. F-11 12" extension 1941 date, 3" F-2 extension dated 1940. Standard

 

<>TWO STEEL KEY MOLDS/STAMPS<>I have two steel key molds,stamps or dies from a locksmith's collection..The largest one is is 1-3/4"X1-1/4" and 7/8" tall and weighs 3/4 pound..The embossed

 

MORTISING CHISEL 1/8 INCH WIDE VINTAGE TOOL For sale is a vintage mortising chisel. This is in used condition and it is 1/8” wide and it is 8 ½” long. Email with questions. This will make a great

 

Vintage Bevelled-Edged Chisel - 8mm. (5/16")Has no maufacturer's mark on the blade but going by the ferrule, and what remains of the decal on the handle, I'd say it's E.A BERG.Blade has some residual

 

Here is a lot of 3 vintage hand scythes or sickles. They are in solid condition for the most part. They do have some rust in places, some pitting, and some wear. Two of the three are unmarked as far a

 

Check out the pictures below, for some auctions there may be more than shown above. Marked on the back KEEN KUTTER and 9 for the 9 inch blade length. A little light surface rust to clean off and a sha