Wood Clamps - Lot of Seven Vintage Hand Screw Wood Clamps You are bidding on a lot of seven vintage wood clamps of various sizes and makes...including... 1. Two small clamps - Unmarked - Size...10 inc

 

Up for auction is this nice, well made old hardy for a blacksmith anvil. Measures approx. 4" long overall; shaft measures approx. 1" across (made for a 1" hole). Looks like the shaft has been shimmed,

 

Huge selection of Bonney, Armstrong, Fairmount and Billings aircraft service wrenches. I've been collecting these wrenches for a while to get the set that I wanted. Their all in great to good conditio

 

Stanley G12-060 plane is 6-1/4 inches long 1-3/4 wide and made in England . About a 1/8 inch chip on bottom piece at blade slot, see picture with red tipped pen pointing to it. Bottom has several larg

 

In this auction you are bidding on : .....VINTAGE CRAFTSMAN NO.1 THIN TAPPET WRENCH.... Marked: CRAFTSMAN NO.1 VANADIUM FORGED IN USA 17/32” – 7/16”, 10” long. This Wrench shows some minor wea

 

Five Swedish Chisels. From Left to Right: 1/2", can't make out name, but I think it is a Berg. The Sweden is at right angle to the fish symbol, like the Berg chisels; 1/4" No name, marked Sweden with

 

Pair of OEM Coil Spring Compressors # 27035 For Coil Spring max round outside diameter 5-5/8" , max spring wire diameter 3/4".Approx. overall length of tool: 12" Good used condition.Made in USAListing

 

This is a Disston D-8 hand saw that is just over 28" in length and has 6 teeth per inch. The blade is rust free and has no bends or kinks. Tha handle has its original finish and the top horn part ofit

 

dropclick Store

 

10" Brass backed Dovetail saw by Tyzack Sons & Turner. This 10" brass backed dovetail saw made by Tyzack Sons and Turner of Sheffield, No 120Blade is clean and straight.The teeth are all present,