Mysterious sprayer or torch, silver colored metal with a tank and pressure pump, valve releases contents through neck and choice of two different nozzles. Looks like the old brass blow torches but no

 

I am listing to sell this vintage Delta hinged table extension. This is used, measures 12" in length, 5- 1/4" in width, due to its age there could be some surface rusting, scrapes, dings, scuffs but s

 

YOU ARE LOOKING AT A VERY NICE GOODELL & PRATT CO. JEWELERS VICE. IT IS SIGNED GOODELL & PRATT CO.GREENFIELD MASS USA. IT HAS 1 1/8" WIDE JAWS AND IS IN GOOD WORKING CONDITION.

 

VINTAGE CRAFTSMAN WOODWORKING TOOL ~~~~~ BLOCK WOOD PLANE BLOCK WOOD PLANE # 3704 INCLUDES ORIGINAL BOX --- BOX IS BEAT UP / TORN CONDITION: SEE CONDITION ABOVE ... CHECK OUT MY PICTURES! **CHECK OUT

 

NO RESERVE!!!! 6,676 POS. FEEDBACKS , [ NEVER A NEG. ] THE REASON FOR THIS , I BELIEVE IS MY DESCRIPTION BELOW I TRY MY BEST TO TELL IT THE WAY IT IS , [ GOOD OR BAD ] [ NO DECEPTION OR GREED AT ALL,

 

Pictures say it all, I took photos close up so you can see it better, been around for awhile, 1940's....does have some rust areas...could benefit from a good cleaning

 

Plumb Axe 4&1/2lb. A bit rough with the poll cracked and has been welded. 6&3/4" blade from poll to blade edge. 5" wide blade Overall length is 800mm. Older original Handle which is in fair/go

 

SAW COLLECTION DISSTON JEWELERS SAW KNIFE COMPASS. Keyhole saw, cast iron handle, 7" blade, unmarked, but probably made by Disston, marked PATENTED AUG. 28, 1877, jewelers saw, steel with wood handle,

 

THIS A PARK 3 DRAWER MACHINIST TOOL BOX20" ACROSS AND 10 1/2" TALL TOOL BOX IS IN GOOD CONDITION LATCHES ARE RUSTY BUT WORK FINE DRAWERS LOCK IN PLACE WITH TOP LID SHUT I DO NOT HAVE THE KEYHAS I INSE

 

Vintage Bench Top Mount Vise. 7 " long , Jaws 2 1/2 " wide. Jaws open to a maximum of 2 1/2 ". Four screw holes will allow you to mount the vise anywhere on the work surface. Although this particular