Very Good Condition . Ballston , N.Y. with 6" blade . Minor surface rust . Weight 2 lb. 10 oz. In regards to shipping we will use flat rate boxes if it will be cheaper , depending on your location .

 

The item you are bidding is a scroll starter used buy blacksmiths to start the delicate ends of a scroll. The tool you're bidding is 3 3/8" long and 2 3/4" wide and aprox. 1" deep. This is a very usef

 

Bernz No. 7 Self-Acting Torch / Blowtorch - This little self-acting, 1/4-pint gasoline blowtorch was manufactured by the Otto Bernz Company of (I believe) Rochester, New York. I say “I believe” be

 

For auction is a set of three antique slate roofing tools probably made in Bangor Pennsylvania but that is a guess. The name stamped on the hammer is AP Koplin and I believe that is the name of the ma

 

Heavy duty cast iron slide action hammer nail puller . Unusual design on this one , embossed name is '' BULLDOG '' . Measures 17 inches closed , slide hammer in the open position 22 inches long , heav

 

This hand saw is very rustic but with the right person it can be brought back to life. Someone has painted one side of it white. The other side is original rustic. Great for someone who paints picture

 

i000000 Vintage RECORD UK Model:730 Fibreboard Plane vgc Old Tool Click Images to Enlarge You are bidding on a vintage RECORD UK Model 730 Fibreboard Plane & Cutters in good condition. All parts o

 

Early antique saw vise weighing almost 6 pounds. About 9" length. Jaws 9 1/4" wide. VG condition except bench bolt is broken. Diameter of bolt is approx 7 centimeters. Could be replaced or repaired. A

 

Very Rare Clayton & Lambert No. 8 Blowtorch, unmarked!! – This self-acting blowtorch was manufactured by the Clayton & Lambert Mfg. Co. of Detroit, Michigan, and dates from July, 1900. To op

 

This listing is for a 12 point, Snap-On-Tools,OEX20A, 5/8" combination wrench in very nice used condition. This tool measures 9 1/2" long. Thank you for looking.