Antique Flathead Screwdrivers. Wood/Steel. Mostly Germany Made.

 

This is an antique hammer/mallet by E C Atkins & Co. It's #3 and measures 13.25 inches long. There is some damage to the end of the handle, otherwise, it's in excellent condition! Buyer prepays in

 

Large heavy cut off hardy for big anvil. Fits 1-1/4" hardy hole.6-1/2"" overall length, 2" wide. In good shape, ready to use. I have other blacksmith tools listed, and will combine shipping. Thanks

 

Sorby woodcarving gouge #6002 1/8" 3 mm skew in good condition but used holds a good edge

 

. **** nice set of 12 6 in lathe tools. comes in a plastic container. **** Please try and judge by pictures and ask questions. Thanks and good luck bidding. We do combine shipping and if it gets heavy

 

You are bidding on a Great Assortment of Vintage Keys. There are over 100 keys in this lot. There's 1 small cabinet key, some flat steel cut keys, about a dozen of the old master keys with lions and s

 

Bob is marked K&E CO. N. Y. see photo three. This is a working bob with three types of metal. The very top is brass the top middle section looks like copper. The bottom middle is brass and the ver

 

VINTAGE CAST IRON 10" WET STONE SHARPENING GRINDER. 3 1/2" WIDE, 11 1/2" TALL TO TOP OF WATER SHIELD,GRINDER BASE IS 12" LONG HAS DRAIN PLUG, ADJUSTABLE GUIDE FOR GRINDING,THE IRON WATER SHIELD ADJUST

 

UP FOR AUCTION IS TWO JH WILLIAMS DEEP THROAT CLAMPS IN ORIGINAL BOX. CC-404 AND CC-406. BOTH CLAMPS APPEAR TO HAVE NEVER BEEN USED AND HAVE A T ON THEM IF THAT HELPS DETERMIN THERE AGE. PLEASE EMAIL

 

floats Maru-Nomi - signed One from a set of 19 of mainly Juno chisels of different that will be on auction over the next few days. This chisel was part of the set and was used by the craftsman in his