This listing is for a 12 point, Snap-On-Tools,OEX20A, 5/8" combination wrench in very nice used condition. This tool measures 9 1/2" long. Thank you for looking.

 

UP FOR SALE IS A VINTAGE HAND FORGED BLACKSMITH HAMMER SEE ALL 6 PHOTOS FOR SIZE AND CONDITION THANKS & GOD BLESS

 

I AM LISTING A GREAT OLD VINTAGE CAST IRON AND WOOD BARN PULLEY. IT MEASURES ABOUT 11 " TALL AND 6 1/2" WIDE. THIS PULLEY HAS BEEN CLEANED AND SPRAYED WITH A CLEAR LAQUER TO PRESERVE THE ANTIQUE PULLE

 

Up for grabs is bad ass little fully custom fish bat or tire tumper that has been all hand turned by me, this bat is approx. 16 inches long......I did a Nomad theme on her, she has a rad evil shape go

 

budgie2cheap Store An old 10 tpi saw by Disston,Philadelphia.good teeth,quite sharp,would benefit from a final honing.all nuts present,some splashes of paint on handle,but solid with no breaks.straigh

 

Smaller antique English molding plane with a convex blade to produce a concave profile of about 1/4 inch width. There appears to be a maker's mark but I cannot make it out but may be "_rowell (perhaps

 

PLUMB USA Axe: 4&1/2lb. Great condition. No chips or cracks. 7 & 1/4" blade from poll to blade edge. 5&1/2" wide blade Overall length is 790mm. (31") New Spotted Gum Handle. ** See my othe

 

Great collectible and very nice condition. Measures 5" long x 1 1/2" tall x 1 1/2" thick. Has a large H inside a crest and along one side the letters B & O R . No chips, cracks or repairs. No hadl

 

vintage hand drill stanley NY-LO-DRIVE EGGBEATER NO.H1220 MADE IN USA WORK GREAT

 

Your browser does not support JavaScript. To view this page, enable JavaScript if it is disabled or upgrade your browser. Click Here. Double your traffic. Get Vendio Gallery - Now FREE! VINTAGE STARRE