YANKEE No. 41 drill, screw driver, with 10 bits, shows some wear and light rust on finish, works smooth Returns accepted email questions

 

Two (2) Hargrave "Superclamp" Cincinnati Tool 6" No. 44 C-Clamp This pair of c clamps are in good working condition. They show some wear, surface rust and needs some oil.

 

Antique Ball Peen Hammer 1 1/4 lb My Dad's hammer from back in 1930s or 40s

 

You are bidding on a VINTAGE E.C. SIMMONS KEEN KUTTER DOUBLE BIT BROAD AXE No.50. We are not sure if it is the original handle. Overall length is approx 35 1/2". Axe head is about 8 1/4" x 4 1/4". Han

 

Up for auction is a Vintage Brush Axe. It is in used condition. The overall length is 40 1/2 inches. The handle is solid. It is being sold as is. Payment is expected within 5 days of auction end. Than

 

Nice old antique lock an on the front lock works fine opens and locks. The key looks like it says Corbin and 407 on back of the key. Shipping $4.75

 

COLLECTABLE --GREAT GARAGE ITEM---LOT OF 2 DANGER SIGNS --FLASHING RED BATTERY OPERATED-- BATTERY---SIZE ' D' 2 IN EACH LIGHT # 1--LIGHT--WORKS GREAT AND LOOKS NEW--V GOOD CONDITION. # 2--LIGHT--BATTE

 

Welcome to my Auction. Up for bid today is a Key-Bak key chain holder..made in U.S.A. The round holder has an approximate 2-inch diameter x 5/8-inch thick (including belt loop)...this has a 23-inch ch

 

C.E. Jennings 4 Drawer Machinist Tool Chest of Black Walnut & Chestnut. Size 18 3/4 x 12 3/4 x 11 3/4 inch. Excellent Condition with some of the following tools. Goodell Pratt No. 97 hand vise, Go

 

1929 STANLEY TOOL CATALOG nO 34- SOFT COVER