This auction is for a vintage Craftsman wood plane with the original box and 20 page pamphlet The plane is 9 ½ inches in length. It is in very good barely used condition. There is no damage or repair

 

4½" INCH WIDE BLADE DRAW KNIFE FOR FURNITURE MFG OR WOOD CARVING clean tool, solid handles, unknown mfg - new conditionWITH LEATHER SHEATHCheck out my other items!

 

Up for sale are two used, well cared for, scarce and rare matched set of 5/16” tongue and groove woodworking planes made by H. Wilson in Newcastle England. These planes were made in the 1800's, they

 

VINTAGE PROTO 1430 BRASS HAMMER - IT HAS DINGS AND SCRATCHES FROM PRIOR USE, THE ENDS HAVE MUSHROOMING ON THEM AS WELL LOOK AT PHOTOS. . IT IS STAMPED PROTO 1430 MADE IN USA. THE HANDLE IS NICE AND TI

 

Description/Condition: You're bidding on a adjustable throat, knuckle joint lever cap Stanley block plane No. 18 in good condition and complete. The plane has minor wear due to vintage of plane The le

 

H. Disston & Sons No.112. 22" rip saw. Some staining on the blade as shown. No pitting. 10PPI. Teeth are good. Small chip in handle as shown. This is the skew back version of the No.12. Good saw a

 

Early complex 18thC moulding plane. 18thC looking moulding plane, flat shoulder with moulding detail to edge.No makers name.Profile is a Cove & Astragal with cove, ( 1 3/8" x 7/8") Original blade

 

> Four large heavy skeleton keys - Very decorative > Each one is a different shape 1st) 6 1/2" Long with a 1 3/4" Head 2nd) 5 1/2" Long x 1 1/2" Head 3rd) 5 1/4" Long x 1 1/2" Head 4th) 4 7/8" L

 

VINTAGE TRUE TEMPER, GENUINE, CARPENDERS HATCHET AXE HEADAXE HEAD IS 6 3/4" LONG AND WEIGHS 1 LB 12 OZ AXE HEAD IS USED IN GOOD CONDITION.VERY LIGHT PITTING AND SURFACE RUST. EYE IS IN GOOD SHAPE AND

 

PLUMB BOB by GENERAL HARDWARE #800-8. It's an 8 ounce. In very good condition. No sign of use that I can find, just normal aging. Complete with original tube which also in very good shape.