Unusual Stanley markings, 5 1/2 on frog bottom, O on blade and USMC on chip breaker. Only apology a chip off the side of the heal, as shown in both pictures. The Tote hold down screw is brass too, I h

 

OLD SNAP ON COTTER PIN PULLER 10 INCH, NUMBER S 9094 B. IN GOOD USABLE CONDITION, USED WITH WEAR.

 

VINTAGE Craftsman Wood Carving Set 8 Pcs Chisels Set Product Description: Chisels are used, with scratches/signs of use. The case has wear & tear. Forged Tapered BladesVanadium High carbon SteelHa

 

Used, probably not maintained as well as should have been.............. nonetheless looks to be in condition to be restored

 

YOU ARE looking at a CHAMPION BLOWER & FORGE CO model 102 post or wall mount drill press ABOUT 50 LB weight, made by champion blower and forge co lancaster Pa. It turns ok power feed works table &

 

Japanese vintage bench chisel. The brand is SHIGEMARU. The chisel has been sharpened with #800 water stone. The cutting edge is 42mm. The length is 178mm. The weight is 171g. I will combine the items

 

LARGE LOT USED Machinist Tools Cutters 3 or 4 have Carbon tips

 

This listing is for a set of Bernard parallel jaw pliers. The pliers are a older set but still very usable. The pliers have had some clean up done but still have scratches and blemishes as well as wea

 

MADE IN ENGLAND -- 26 - POINT - DOVE TAIL SAW -- ITS - 9 - 5/8 - INCHES LONG OVERALL -- THE BLADE IS - 5 - 1/16 - LONG -- 5 / 8 - OF AN INCH UNDER THE BACK -- HAS A BRASS BACK & COPPER FERRULE --

 

This plane un cleaned, is marked on one side Stanley, on the other side is No. 78 made in U.S.A., marked at the top of the single blade is Stanley, with their S.W. Sweet Hart logo, made in U.S.A., it