Here is a nice double bit axe head I bought it at an auction and just cleaned the rust off needs to be sharpened Posted with eBay Mobile Posted with eBay Mobile
Bernz No. 7 Self-Acting Torch / Blowtorch - This little self-acting, 1/4-pint gasoline blowtorch was manufactured by the Otto Bernz Company of (I believe) Rochester, New York. I say “I believe” be
SMALL BENCH VICE FOR JEWELLERS OR SILVERSMITHS ETC MADE WITH HAND RIVETS MEASURES 9 CM LONG. THE JAWS ARE 27mm LONG & 8 mm DEEP THE VICE CLAMPS NICELY BUT THE BENCH ATTACHMENT SCREW IS WORN SO IT
This bid is for a group of 9 vintage saw sharpening tools, all for one bid. Included is 3 joiners, one marked Disston,one is cast aluminum. The 6 tooth sets are marked 2 are marked Taintor's Positive
This Stanley #118 low angle block plane is in very good used condition. This plane is a low profile model made of stamped steel rather than cast iron. Consequently it is not subject to cracks or break
You are bidding on a lot of 10 assorted skeleton keys. The keys are all in pretty good condition and show normal wear and tear of their ages. Bid with total confidence with us! and make your satisfact
This auction is for a rare vintage "Powr-Kraft" Montgomery Ward 1/4" Drive Ratchet. The ratchet is used, shows some light wear and is in good working condition. No.4758 00 5" long There are No owners
I have for auction these two vintage lakeside carpenter chisels. the large one is a 2'' wide chisel. and it is 15 inches long including the handle. The second chisel is also a lakeside . It is 1 3/4''