tHIS I SOLD AND ORIGINAL.IT IS IN PERFECT WORKING ORDER AND IT IS COMPLETE.IT HAS HAS A COUPLE OF REPAIRS AS SEEN IN THE PHOTOS AND AND A CHIP PHOTO 7.I HAVE TAKEN A FEW PHOTOS TO SHOPW THE CONDITION.

 

Hi - thanks for taking the time to check out this handcrafted woodworking tool. It has been turned from solid oak and signed by the turner, (who happens to be me). The length is 10-1/16", the head has

 

ON THE SCHAKLE IS STAMP - SHAPLEIGH HDW, CO AROWN THE KEY WAY IS STAMP - SIX TONGWEAR LEVER 1 WORKING KEY IT LOOKS ORANGAL KEY ? SERVICE RUST ON THE LOCK 3 3/4 H - 11/16 W SHIPPING 1 TO 10 DAYS U.S. A

 

THIS EARLY WINCHESTER FLASHLIGHT IS IN REAL NICE CONDITION FOR IT'S AGE, BOTH ENDS OPEN AND CLOSE NICELY AND THE SWITCH WORKS. THE BOTTOM IS MARKED 'WINCHESTER FLASHLIGHT' OVER A LARGE LETTER W. PAYPA

 

Vintage MALL DRILL wit Right Angle Drive AdaptionThis Drill Runs Good, I don’t know what the Right Angle Drive unit does for sure but I believe it adapts other accessaries to the head for limited ar

 

I HAVE UP FOR SALE A VINTAGE HEXACON MODEL P130 SOLDERING IRON WITH THE ORIGINAL BOX. IT'S IN VERY GOOD CONDITION AND PERFECT FOR ANY COLLECTOR. NOTE: I ALSO HAVE THE P150 IN THE ORIGINAL BOX UP FOR S

 

LOT OF 6 OLD TANG CHISELS 3 BEVEL EDGE AND 3 WIDER SWEEP GOUGES ALL 4 ARE JUST SHY OF 1/2" WIDE ALL DISPLAY SPOTS / AREAS OF RUST AS SHOWN IN PHOTOS ALL OFFERED AS IS Check out my other items!

 

Beautiful large antique/vintage Chinese tap and die sets - each box measures 19.25 by 5 inches

 

very nice yankee hand drill in good vintage condition as you can see!! it has some little rust spots but 90% is bright and shiny! very great collector item shipping will be $12.99 Cont US only, NJ res

 

5 OF THEM HAVE CURVED CUTTING EDGES AND THEY RANGE FROM 3/16 INCH TO 1 INCH WIDE. THE OTHER TWO ARE 1/4 INCH WIDE AND 5/8 INCH WIDE. THEY ARE ALL MARKED BUCK BROS. THE LARGEST CURVED ONE HAS A CHUNK O