Very nice clean mini ball bearing chuck. 0 - 1.5. Made in Germany. Buyer pays actual shipping. Paypal accepted.

 

Smaller antique English molding plane with a convex blade to produce a concave profile of about 1/4 inch width. There appears to be a maker's mark but I cannot make it out but may be "_rowell (perhaps

 

This WR V6 plane is excellent condition showing very few marks from light use.  Very light marks on handle, in picture, and even lighter marks on knob.  Sharp blade is ready for action as shown.  I

 

I am selling a used original Plomb 5449 1/2'' ratchet. It is in good working order. Pebble finish. Selector will go too far to either side but if kept in normal operating areas works fine. It is a 60

 

Good + Condition. The thoughtful restorer could do a lot worse than this. Surface rust. Almost all parts except bulbous hand part that retains blade, and, the blade itself. All the parts except the kn

 

Here we have fresh of the bench is a nice old hand forged blacksmith hot cut style hammer, this is a rad old head, and once mounted up and sharpened it seems like a blacksmith tomahawk to me..........

 

Galv tin patterns don't know much about them except hard to find ,of great interest , make up your own mind.

 

NICE OLD SET OF K-D REVERSIBLE RATCHET BOX WRENCH SET WITH A DOUBLE SCREWDRIVER TIP, THAT FITS IN THE 3/16THS RATCHET. ONE BLACK CLOTH CARRYING CASE. SIZES: No.24(9/16), No. 23(1/2), No.22(7/16), No.2

 

This auction is for a vintage WINCHESTER OLIN FLASHLIGHT that is considered used condition and does work and red button is kind of melted . I'm not really sure what this attachment is  but it narrows

 

Up for your consideration is an Older Vintage / Antique SARGENT & CO. Steel DIVIDERS 12" Marked with the 12 on one leg and SARGENT & CO. on the other. These Dividers work real well as intended