they are used and have sings of were and has rust on them thanks

 

Here's a Nice Antique Leather Cutter...Marked..."CS Osborne & Co Dated 1877" and More...see pics...About 135 Years Old...The Numbered Sliding Bar Is about 6" Long w Thumb Screw...Handle Part about

 

STANLEY BLADE SINGLE PLANE IRON 2 IN. HIGHEST QUALITY MEASURES 7 1/2" LONG X 2" WIDE HAS ORIGINAL PAPER COVER CONDITION ~ NEW

 

You a snap on punch holder New never used. Any questions please ask

 

Item is a wicked blow torch, gasoline type, with a valve stem to pump air into it. It has a pressure gauge and complete instructions on how to fill, light and put torch out. I believe it will work sti

 

NICE LOOKING USED CONDITION ~ VINTAGE ANTIQUE SINGLE HUMP UNMARKED MORIN #5 CAST IRON 3" X 1-1/2" CROSSCUT SAW FILER TOOTH SPIDER SETTING GAUGE ~ THESE TYPE TOOLS, WERE ONE OF THE MANY PREFERRED TOOLS

 

Up for grabs is bad ass little fully custom fish bat or tire tumper that has been all hand turned by me, this bat is approx. 16 inches long......I did a Nomad theme on her, she has a rad evil shape go

 

GENUINELY SCARCE, ORIGINAL 1890 BLACKSMITH EQUIPMENT CATALOG. This wonderful 19th century circular was published by the P. H. & F. M. Roots Co., Connersville, Indiana. Established in 1859, the pio

 

This listing is for a set of Spintite nut drivers. Spintite was made by the Stevens Walden Co.. The nut drivers have had the handles cleaned and restored. The nut drivers do have scratches and blemish

 

Good afternoon folks....Today i am going to list several blacksmith anvil hardys, picked by me out of an old blacksmiths sons workshop...Most are big and impressive, and will fit a 7/8th inch hardy ho