RARE MINT "ATHA" Half Round Hot Cut Hardy.. Here is a chance that most small anvils owners dont get very often ... This is a MINT N.O.S. ATHA half round Hot Cut with a factory small 1/2" hardy shaft..

 

These were never used, but show a little shelf wear from sitting in the shop for a few years. An interesting way of gluing up solid panels. Per the Lee Valley web site they stop cupping and bowing of

 

PLEASE CHECK THESE PICTURES. IF YOU HAVE ANY QUESTIONS, PLEASE E-MAIL ME. The pictures are all of the front of the sticks. Listed below are sizes and condition to the best of my ability. 1) Ruler, 12"

 

In this Auction:Early Vintage 2 inch Special Stanley Rule & Level Co. Measure. Appears to be made of Catelin Plastic. Has someone's name etched on the back. Has one small chip out of back corner a

 

a new reproduction blade set for the stanley #41-#44 plane 9 cutters 1/8"-3/16"-1/4"-5/16"-3/8"-7/16"-1/2"-5/8" toung 1/4" Rc64-66

 

Mrsdeadhorse Store Here we have rare find and that would be an older DISSTON Dovetail back saw that dates from about 1870-1875 period and that is in EXCELLENT condition. Has an original 10 inch blade

 

Up for auction is a Vintage Star Key Advertising Store Display with over 350 Blank Keys - most of them brass There are key blanks for doors and cars (50s to early 70s) and others. The board is 24" X 1

 

This old double-beam marking gauge is in excellent working condition with a very slight warp in one of the beams that shouldn’t hinder its use. There are fewer than expected scratches, scuffs, etc.;

 

This is an old tool catalogue from 1897 put out by Montgomery & Co., New York City, New York. It is catalogue No. 21. The covers on this book are worn and soiled as seen in the photos but are not

 

&amp